Hyundai Tucson: Rear Door
READ NEXT:
WARNING
Check the glass run channel for damage or deterioration, and replace
them if necessary.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
Lower the glass by operating the power window switch until the gla
Component Location
Rear door trim
Replacement
WARNING
When removing with a flat - tip screwdriver or remover, wrap
protective tape around the tools
to prevent damage to components.
Put on gloves to prevent hand injuries.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
After loosening the mounting screws, remove the rear door inside handle
(A).
To install, reverse removal procedure.
WARNING
Make sure the door locks
SEE MORE:
Remove the heater pipe
Disconnect the oil cooler hose (A) from the ITM.
Disconnect the oil cooler hose (A) from the oil cooler.
Rmove the oil cooler pipe (A) after loosening the mounting bolts.
Tightening torque :
9.8 - 1
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important
sensors of the engine control system. If there is no CKPS signal input, fuel is
not supplied.That is,
vehicle can't run without
Rear Door - Glass Adjustment
