Hyundai Tucson: Clutch touch-point learning
WARNING
- Clutch touch-point learning status can be checked through the cluster lamp.
- Prior to learning. "E" lamp turns on. After learning, the
current gear position (N) replaces the "E" lamp and blinks.
- Check the below sensor data by using the diagnostic tool.
(1) Current gear "N"
(2) Accel. Position Sensor 0 %
(3) Clutch pedal sensor 0 %
WARNING
- Engine power on
- Current gear "N"
- Accel. Position Sensor 0 %
- Clutch pedal sensor 0 %
- When the engine power is turned on, the touch point learning would be performed automatically.
WARNING
If driver interrupt the learning by manipulating any pedals, the learning would be stopped. When the condition of the learning is satisfied, the learning would be performed anytime.
- Check a sensor data value.
"Touch-point learning finished"
WARNING
If the shift lever is located "N" but the sensor data of "Current gear" isn't displayed "N", inspection of the lever and control cable is required.
(Refer to I\IT(intelligent Manual Transaxle) Control System - "Control Cable")
Torque - Stroke learning
WARNING
- Clutch torque - Stroke learning status can be checked through the cluster lamp.
- Prior to learning, the current gear position (N) lamp blinks.
After learning, the current gear position (4) lamp lights up.
- Drive the vehicle with below condition.
(1) Launch the vehicle and shift gear 1 → 2 →3 rapidly under 30 kph.
(2) Drive the vehicle with below APS 30% in 3rd gear for about 20 seconds up to 70 kph. (APS have to be keep the least of fluctuating)
(3) Shift the gear to 3rd →4th above 70 kph vehicle speed.
- Check a sensor data value.
"Torque - stroke learning finished"
In case by recomened procedures (2)
Clearing of learning values
- Perform IMT clear learning values procedure using the diagnostic tool.
READ NEXT:
Filling check
WARNING
The procedure below shows about residual air check and removing
it if necessary by using the diagnostic tool after refilling
the IMT system with clutch fluid.
The "IMT filling check" procedure should be performed after
IMT Control Module (TCM)
Description
Function
The transaxle Control Module (TCM) is like the brain for the Intelligent
Manual transaxle (IMT). It
receives information from various sensors for a wide range of transaxle controls
to provide an optimal
driving environmen
IMT System Actuator
Components and Components Location
IMT system actuator
Connector and Terminal Information
Circuit Diagram
SEE MORE:
Fender
Component Location
Fender assembly
Replacement
WARNING
When removing the fender, wrap protective tape around a
screwdriver or remover not to damage
components
Put on gloves to prevent hand injuries
Remove the front bumper
eCall Parameter Download
eCall Parameter Download is used to change the parameter value of the eCall
law in Europe.
Turn the ignition switch OFF.
Connect the diagnostic tools.
Turn the ignition switch ON without the engine running.
Select the "Car Model"
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
