Hyundai Tucson: Intelligent Manual Transaxle (IMT) System
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Intelligent Manual Transaxle (IMT) System
- General Information
- Intelligent Manual Transaxle (IMT)
- Intelligent Manual Transaxle (IMT) Oil
- IMT System Learning Procedures
- IMT Control Module (TCM)
- IMT System Actuator
- IMT System Actuator- Replacement
- IMT System Actuator- Inspection
- IMT System Actuator- Removal
- IMT System Actuator- Installation
- Gear Position Sensor
- Speed Sensor
- Shift Lever
- Control Cable
- Control Shaft Complete
READ NEXT:
Specifications
IMT system actuator
Gear position sensor
Gear position sensor select lever - signal code table
Speed sensor
IMT system actuator fluid
Tightening Torques
Lubricants
Sealant
Special Service Tools
Tool
(Numb
Troubleshooting
Trouble symptom/ Suspected area/ Remedy
Abnormal noise
Oil level (Low)
Add oil after inspecting the
parts, (oil seal, drain plug, filler
plug)
Oil (Wrong or contaminated)
Replace the oil.
Transaxle and engine mounting
SEE MORE:
Front Brake Pad
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
Remove the front wheel and tire (A) from front hub
WARNING
Be careful not to damage the hub bolts when removing the front wheel
and tire (A).
Ower Seat Motor
Component Location
Lumber support motor
Reclining motor
Front height motor
Slide motor
Rear height motor
Lumbar support switch
Reclining switch
Power seat switch
Inspection
Ower Seat Motor
Remove the front seat assembly.
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual