Hyundai Tucson: Gear Position Sensor
Components and Components Location
- Gear position sensor
Connector and Terminal Information
Removal
- Remove the IMT system actuator.
(Refer to Intelligent Manual Transaxle (IMT) Control System - "IMT System Actuator")
- Loosen the bolts and then replace the gear position switch (A).
Tightening torque : 39.2 - 58.8 N.m (4.0 - 6.0 kgf.m, 28.9 - 43.4 lb-ft)
Installation
- To install, reverse the removal procedures.
READ NEXT:
Speed Sensor
Components and Components Location
Control shaft complete
Description
Component location : Control shaft complete is mounted on the top of the
manual transaxle, and
select & shift cable are equipped.
Function : Change the ge
Shift Lever
Removal
Turn ignition switch OFF and then disconnect the battery (-) cable.
Remove the floor console assembly.
(Re fer to Body (Interior and Exterior) - " Floor Console")
Remove the floor air duct (A).
Separate the wi
SEE MORE:
Rear seat back cover - RH
Remove the rear seat back assembly RH,
(Refer to Rear Seat - "Rear Seat Assembly")
Loosen the mounting screw, remove the rear seat slide knob (A).
Loosen the mounting screws, press the lock pin (B) and remove the rear
se
Blind-Spot Collision-Avoidance Assist (BCA)
BCA activating conditions
(1) User Setting Menu (USM): Select 'Driver Assistance' -> 'Blind-Spot Safety' -- 'Blind-Spot Collision-Avoidance-Assist'
(2) Vehicle speed: 60 kmh - 200 km h
(3) Curvature radius: 600m or more
(4) Both lanes
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
