Hyundai Tucson: IMT System Learning Procedures
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Intelligent Manual Transaxle (IMT) System / IMT System Learning Procedures
READ NEXT:
IMT System Learning Procedures - Adjustment
IMT System Learning Procedures Table
* Refer to the following table to perform the diagnostic tool learning
procedure.
IMT system learning stams can be checked through the cluster lamp.
Ill case by recompiled procedures (1)
Clear
Clutch touch-point learning
WARNING
Clutch touch-point learning status can be checked through the
cluster lamp.
Prior to learning. "E" lamp turns on. After learning, the
current gear position (N) replaces the "E" lamp and blinks.
Check t
Filling check
WARNING
The procedure below shows about residual air check and removing
it if necessary by using the diagnostic tool after refilling
the IMT system with clutch fluid.
The "IMT filling check" procedure should be performed after
SEE MORE:
ETC (Electronic Throttle control) System
Description
The Electronic Throttle Control (ETC) System consists of a throttle body with
an integrated control motor and throttle
position sensor (TPS). Instead of the traditional throttle cable, an Accelerator
Position Sensor (APS) is used to
Rear Axle Assembly - Removal - 4WD
WARNING
When lifting a vehicle using a lift, be careful not to damage the
lower parts of the vehicle (floor under cover,
fuel filter, fuel tank, canister).
(Refer to General Information - "Lift Point")
Loosen the rear wheel nuts
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
