TucsonDataManu

.com

Hyundai Tucson: Differential Carrier Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Driveshaft and axle / Differential Carrier Assembly

Differential Carrier Assembly - Removal

Components Location Rear differential carrier assembly Rear driveshaft assembly Coupling Assembly Propeller shaft assembly Components Pinion lock nut Oil seal (pinion side) Pinion outer bearing Oil seal (case side) Pa

Differential gear assembly

Remove the drain plug packing (A) and drain plug (B) to drain the gear oil. Loosen the differential side cover mounting bolts. Widen the gap between the side cover and the case to remove the side cover (A). Remo

Pinion drive gear assembly

Fix the differential carrier assembly using the SST (09501-C9230, 0K530-P2500, 0K501-P2232). Loosen the pinion gear lock nut using the SST (09501-C9230). WARNING When istalling lock nut, use a new one. Remove the pinion dr

SEE MORE:

System operation

Front camera operating speed by each system : The operating conditions of the front camera are as follows when the USM of the following system is ON and the required operating speed is satisfied. FCA, Forward Collision-Avoidance Assist

Ambient Temperature Sensor (ATS)

Description Ambient Temperature Sensor (ATS) is installed on the front-end module and senses the ambient temperature. This sensor is exposed to the ambient air temperature in front of the radiator. The ATS is a Negative Temperature Coeffici