TucsonDataManu

.com

Hyundai Tucson: Panorama Sunroof - Installation

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Panorama Sunroof / Panorama Sunroof - Installation

Installation

WARNING

In order to mount the front glass, use the tools shown in the following figure :

Tooling Diagram

  1. Sealant nozzle
  2. Adhesive sealant for car windows
  3. Sealant gun
  4. Primer
  5. Primer application brush

 

  1. Install the roof side molding (A).

  1. Press panorama sunroof switch to fully close the movable glass.
  2. Use a blade to cut off residual sealant (A) around the front glass attachment area.

WARNING

When cutting off the residual sealant around the body panel, make sure to leave about 2mm of sealant from the adhesive surface.

WARNING

  • Make sure that the body paint surface is not damaged at all.
  • If it is damaged, apply paint or rust inhibitor for maintenance.
  1. Use alcohol or an air gun to clean up the edges of the panorama sunroof frame and front glass.
  2. Use a primer application brush to apply primer around the panorama sunroof frame (A) and front glass.
  3. Use a sealant gun to apply sealant (B) around the panorama sunroof frame (A) after applying the primer.

WARNING

When using a sealant gun to apply the sealant, make sure that the sealant is not cracked to prevent water leaks.

  1. Install the front glass (A) loosely on the panorama sunroof frame.

  1. Check step and gap before front glass (A) is fully mounted.
  2. Apply tape to around the front glass to prevent the glass from coming off.

WARNING

If sealant is excessively applied, it may ooze out of the body. Use alcohol or a cleaning agent to wipe off the residual sealant. WARNING

WARNING

  • Mount front glass and set the car on a flat surface at least for 4 hours.
  • If you have to drive the car. be sure to SLOWLY drive the car for at least 8 hours after mounting.
  • Alert the driver to avoid driving the car aggressively for 2-3 days, or avoid driving it on irregular road surfaces.

    READ NEXT:

     Panorama Sunroof - Removal

    Remove the roof trim. (Refer to Roof Trim - "Roof Trim Assembly") Open the roller blind using the panorama sunroof switch. WARNING Leave 10 - 20cm (0.3937 - 0.7874 in) of the roller blind unopened. Remove the roller blind

     Mirror

     Outside rear view mirror

    Component Location Outside rear view mirror Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries

    SEE MORE:

     Input shaft speed sensor

    Components Input shaft speed sensor 1 (Odd) Input shaft speed sensor 2 (Even) Specification Circuit Diagram Removal Turn ignition switch OFF and disconnect the negative (-) batteiy cable. Remove the air cleaner assembly a

     EGR cooler- Removal and Installation

    Disconnect the battery negative terminal. Remove the front bumper beam. (Refer to Body(Interior and Exterior) - "Front Bumper Beam Assembly") Remove the intercooler mounting bracket (A), and then disconnect the intake temperat

    Information

    2022-2024 © - www.tucsondatamanu.com