Hyundai Tucson: Multifunction Switch
Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Multifunction Switch
READ NEXT:
Multifunction Switch - Components
Steering column
Lighting swtich
Wiper switch
Clock spring
Steering wheel
Driver airbag (DAB)
Specifications
Removal
Disconnect the negative (-) battery terminal.
Remove the clock spring.
(Refer to Restraint - "
Multifunction Switch Inspection
Check for continuity between the terminals in each switch position as
shown below.
Inspection (With Diagnostic Tool)
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (d
Horn
Component Location
Horn switch
Horn relay
Horn (Low pitch)
Horn (High pitch)
Clock spring
Removal
Remove the front bumper assembly.
(Refer to Body - "Front Bumper Assembly")
Remove the bolts and disconnect the h
SEE MORE:
High Pressure Fuel Line- Installation
Install in the reverse order of removal.
Install the high pressure fuel pipe as follows.
(1) Completely pre-tighten the both side nuts (A) on high pressure tightening
area of high pressure fuel pipe
while keeping them vertically.
(2) Ti
Immobilizer System - Removal
Removal
Disconnect the negative (-) battery terminal.
Remove the heater control unit.
(Refer to Heating,Ventilation And Air Conditioning - "Heater Control Unit")
Loosen the mounting bolt,nut,screw and remove the Integrated Body
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
