TucsonDataManu

.com

Hyundai Tucson: Function Of Safety Power Window

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Power Windows / Function Of Safety Power Window

Operation

When driver door power window auto-up switch is operated, safety function is activated.

Safety function condition

When detect the force of 100N (using the lON/mm spring) during the window rising, window is reversed.

Length of window reversing (except holding the auto-up switch)

When detect the jamming during the 4mm - 250mm from top of the door.

Window is reversed until 300mm from top of the door.

When detect the jamming over the 250mm from top of the door.

Window is reversed until 20mm from jamming position.

Length of window reversing (holding the auto-up switch)

When detect the jamming during holding the auto-up switch.

Window is reverse until 25mm from jamming position.

Auto-up function is not available during the 5 seconds from above condition.

When holding the auto-up switch, window is operated as a manual-up function. (Safety function is not activated.)

Safety function is not available area

Safety function is not available during the 4mm from top of the door.

Initializing Method of the Safety Power Window

Initializing of Battery Connection When the battery power is removed for over 5 minutes, safety power window switch need the initializing. (1) Power window operation before initializing Manual-Up/Down function is available Auto-Up fun

Rear Glass Defogger

Inspection Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on the tin foil, moving the tin foil along the grid line to check for open circuits. Turn on the defogger swit

Power Tailgate Module

SEE MORE:

Engine Mechanical System - Removal

Removal Turn the ignition switch OFF and disconnect the battery (-) terminal. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") Remove the engine room under cover. (Refer to Engine Mechanic

Front Muffler

Removal and Installation Disconnect the battery negative terminal. Disconnect the oxygen sensor connector (A). Remove the engine room rear under cover (A). Tightening torque : 7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)