TucsonDataManu

.com

Hyundai Tucson: Floor Console

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body (Interior and Exterior) / Floor Console

Floor Console - SBW type

SBW type Floor console side cover Floor console tray assembly Floor console upper cover assembly Floor console rear mounitng bracket Floor console assembly Component Location SBW type Floor console assembly SBW type - Repla

Floor Console - SBC type

SBC type Floor console assembly SBC type WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. WARNING Tak

Rear console cover

Component Location Rear console cover Replacement WARNING When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. Put on gloves to prevent hand injuries. W

SEE MORE:

Multifunction Switch Inspection

Check for continuity between the terminals in each switch position as shown below. Inspection (With Diagnostic Tool) In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (d

IMT System Actuator- Installation

Installation Install the IMT system actuator (A) and then tightening the bolts. Tightening torque: 19.6 - 26.5 N.m (2.0 - 2.7 kgf.m. 14.5 - 19.5 lb-ft) Lightly install the concentric slave cylinder (B) on the input shaft (A).