Hyundai Tucson: Trunk Trim
Components
- Luggage tray
- Wheel house pad
- Luggage side trim
- Rear transverse trim
- Cargo screen
- Luggage board
READ NEXT:
Rear transverse trim
Component Location
Rear transverse trim
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
Luggage side trim
Component Location
Luggage side trim
Replacement
WARNING
When removing with a flat-tip screwdriver or remover, wrap
protective tape around the tools to
prevent damage to components.
Put on gloves to prevent hand injuries.
WA
SEE MORE:
High Pressure Fuel Line- Installation
Install in the reverse order of removal.
Install the high pressure fuel pipe as follows.
(1) Completely pre-tighten the both side nuts (A) on high pressure tightening
area of high pressure fuel pipe
while keeping them vertically.
(2) Ti
Driveshaft Assembly- Installation
Installation
To install, reverse the removal procedures.
Check the alignment.
(Refer to Suspension System - "Alingment")
Removal
Remove the front drive shaft.
(Refer to Driveshaft Assembly - "Front Driveshaft")
Information
- Home
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Owner's Manual
- Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual
