TucsonDataManu

.com

Hyundai Tucson: Ignition Switch Assembly

Hyundai Tucson - Fourth generation (NX4) - (2020-2023) - Workshop Manual / Body Electrical System / Ignition Switch Assembly

Removal

  1. Disconnect the negative (-) batteiy terminal.
  2. Remove the steering column upper and lower shrouds.

    (Refer to Body - "Steering Column Shroud Panel")

  3. Remove the ignition switch (A) after disconnecting the 6P connector (B).

  1. Remove the key warning and immobilizer connector (A).

  1. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder with key ACC.

Installation

Installation

  1. Install the key lock cylinder.
  2. Install the key warning and immobilizer connector.
  3. Install the ignition switch.
  4. Install the steering column shrouds and crash pad lower panel.

Inspection

  1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.

  1. Check for continuity between the terminals.
  2. If continuity is not specified, replace the switch.

Anti-theft System (UK only)

    READ NEXT:

     Anti-theft System (UK only)

    Components Location UIP(Ultrasonic Intrusion Protection) Sensor UIP(Ultrasonic Intrusion Protection) Siren Description Anti Theft Device Block Diagram This system is designed to provide protection from unauthorised entry into th

    SEE MORE:

     Tire Pressure Monitoring System - Replacement

    Remove the tire. (Refer to Suspension System - "Wheel")  Remove the screw with torx driver (A). WARNING When installing the bead brake, make sure that it does not come in contact with the TPMS sensor. Be careful no

     Front Suspension System- Replacement

    Replacement WARNING When lifting a vehicle using a lift, be careful not to damage the lower parts of the vehicle (floor under cover, fuel filter, fuel tank, canister). (Refer to General Information - "Lift Point") Loosen the fro

    Information